DIY BIKE RACK
All PVC pipe used was an inch in diameter
For every bike “section” – excluding the ends – you will need:
To make the frame, start with the elbow piece, add a long piece into the elbow, a T and the 10″ length. Then add another elbow. You should have an “end pole” finished. Make two of these. Using the “T” piece, add a long length to the T, add another T, then a 10″ length and another “T”. Create as many of these as the sections “poles” you will need. Use the connectors and the 8″ lengths to connect the poles together until you have a frame made. To the center T’s add the 8″ segment so that the rack can lean back on them.